Star-headlight-lantern 7400 Star Lase Instrukcja Użytkownika

INSTALLATION AND INSTRUCTION MANUAL Ultra Low Profile Modular Mini Lightbar PLIT441 REV. A 7/2/13

-7- Replacement Parts

-8- ROTATORSSTROBESLEFTALLEYWORKLIGHTSRIGHTALLEYFLASHERSSP3860-1SP3860-2 SP3860-3 SP3860-4SB4020SP1515SP3015SB1515SB3015TAKEDOWNGRILLLIGHTSSB4040MODE1

-9- CAUTION: High voltages can exist in many of our products. Before attempting service on any of our products, be sure to disconnect power for at

-10- Determining if the bar is properly grounded: 1. While the bar is turned on, using a test meter, measure the voltage from the base of the bar its

-11- Checking multiple non-working strobe or LED heads: If two or more of the heads connected to the same switch are not flashing, follow these step

-12- If you have any questions concerning this or any other Star product, please contact our Customer Service Department at (585) 226-9787. If a prod

-13-

-i- It is the sole responsibility of the owner to ensure the lightbar is mounted securely. Check your light every time you enter the vehicle to ens

-ii- NOTICE Due to continuous product improvements, we must reserve the right to change any specifications and information, contained

-1- • All standard Mini Laser lightbars have a 15’ harness. It has 10-conductors (plus a drain wire and a foil shield). All wires are color coded an

-2- (Wiring Instructions CONT’D) Wire Connections Brown WireOrange Wire516c6a423a3c Feature Apply +12VDC to: Main Power Red Pattern Select Re

-3- Wire Harness Replacement Standard Mini Laser lightbars come with a 15-foot wiring harness. If the harness supplied with the lightbar is not l

-4- Wire HarnessCONTROLCABLEINLETBARE (Ground)BROWN (Enable Rear)WHITE (Synch)ORANGE (Enable Front)RED w/GREEN (Pattern Select)PURPLE (High/Low Select

-5- 1 23a3c456a6c6a 5 4 3a6c 1 2 3aPhase Jumpers• LED heads can be programmed with the user’s choice of “phase”. Each light head in the Laser lightb

-6- (LED Head Programming CONT’D) LED Flash Pattern Selection 1. To program the flash pattern, activate the LED heads that you wish to program b